gemver  80 81 81 81 81 81
gemres  82 82 82
floppy  83


80
The installation program will need to overwrite some of
the files on your GEM distribution diskettes, in order
for the driver to be successfully installed.
   
It is, therefore, highly recommended that the original
GEM diskettes are backed up, and the backed up copies
be used in the driver installation procedure.
   
A disk-copying utility is provided for your convenience
in this installation program.
   
Please make sure that you have a sufficient number of
blank diskettes to copy the original GEM diskettes onto.
   
Press <Enter> to commence the diskette back-up process.


81
Select the version of GEM which you have currently
installed, or about to install in your system.
   
Device Drivers supplied with your card support only
the available GEM software versions as shown in
the menu.
   
Choose the version that you have and press <Enter>.
   
Press <Esc> to abort GEM driver installation.


82
Choose the driver which you wish to have installed, based
on the the resolution and/or the number of colors that
you require for a particular application.
   
It is important to note that not all of the available
drivers may be installed; this is due to the fact that
either your Graphics Card or your monitor doesn't support
the driver of your choice. (i.e. a 1024x768 driver can
not be used with a regular VGA 640x480 monitor).
   
If this is the case, then select the driver with lower
resolution and/or fewer number of colors.
   
Position the cursor over chosen driver and press <Enter>


83
The INSTALL Program has detected 2 floppy drives in your
system. Depending on the format of your original GEM
installation diskettes, you should make a selection
of the floppy drive that will be used for installation.
  
Select drive A: or drive B: for the floppy drive.
  
Type in the letter of correct drive and press <Enter> 


-1


